Christmas treat holder

Renee Lynch Independent Stampin' Up! Demonstrator Australia

I'v been asked for some treat holders inspiration by some of you. So I had a little play and came up with this cute little package. I got some inspiration from the lovely Pootles.co.uk so I cant take all the credit!

This is so easy to make I'll walk you through how!

Measurements

DSP at 10cm x 15cms

Score along the long side at 2.3cm

Score on the short side the full length of the paper at 1cm and 5.5cm

And on the short side only partially up to the first scored line at 3.3cm and 7.7cm

Cut up to divide the four squares and remove the unwanted rectangle on the left side,

Fold on all scored lines, and then fold in half and glue the small side tab in.

Place in the tag topper punch and punch out the top!

Adhere the bottom four tabs one on top of the other to create the bottom of the box

Finally decorate to decorate.
I layered the two circles on top of each other and finished with a dimensional
on the gold snowflake and the HO HO HO banner.
To ensure the top would fully close I added a gold library clip with the cherry cobbler ribbon and the white twine, both Ribbons were adhered to the clip with a glue dot!